SDO200 SERIES
DIGITAL STORAGE OSCILLOSCOPE
Features
. Dual-channel oscilloscope with 25MHz signal generator (model s)
. 100MHZ, 150MHz, 200MHz bandwidth
. Dual-channel independent 1GS/s real-time sampling rate
. 20M memory depth
. Support 30 Automatic Waveform Measurements
. 6-digit High-precision Frequency Counter
. FFT Spectrum Analysis
. Communicate with PC via USB Device interface, support SCPI
and LabVIEW functions, provide free computer software and
some programming development demos, so you can remotely
control the instrument and conduct secondary development.
. 7-inch TFT LCD display
. Dual-channel oscilloscope with waveform generator (SDO210S, SDO220S only)
Technical Data | SDO210/SDO210S | SDO220/SDO220S |
Input | ||
Input coupling | DC, AC, GND | |
Input inpedance | 1MΩ±2%, in parallel with 12pF±5pF | |
Probe attenuation coefficient | 1x, 10x, 100x, 1000x | |
Maximum input voltage | 400V (DC+AC, PK - PK) | |
Chanel to chanel isolation | 50Hz: 100:1 / 10MHz: 40:1 | |
Time delay between channel (Typical) | 150ps | |
Vertical | ||
Analog bandwidth | 100MHz | 200MHz |
Rise time (Typical) | ≦3.5ns | ≦1.75ns |
Channels | 2 | 2 |
Vertical scale | 8 bits | |
Bandwidth limit (Typical) | 20MHz | |
Low frequency response (AC coupling, -3dB) | ≧ 10Hz (on BNC) | |
DC gain accuracy | ±3% | |
DC accuracy (average) | Delta volts between any two averages of ≧16 waveforms acquired with the same scope setup and ambient conditions (ΔV): ±(3%reading + 0.05V/div) | |
Displacement | ±1V (2 mV/div~100 mV/div), ±60V (200 mV/div~10 mV/div) | |
Waveform inverted | ON/OFF | |
Horizontal | ||
Time scale | 2 ns/div~1000 s/div/div, step by 1-2-5 | |
Timing accuracy | ±100 ppm | |
Interval (ΔT) Accuracy (DC-100MHz) | Single : ±(1 interval time + 100ppm x reading + 0.6ns) Average>16: ±(1 interval time + 100ppm x reading+ 0.4ns) | |
Sampling | ||
Sampling rate range | 0.5 S/s~1G S/s | |
Interpolation | (Sinx)/x | |
Acquisition mode | Normal, Peak detect, Averaging | |
Memory depth | 20M | |
Trigger | ||
Trigger level range | Internal: ±4 div from the screen center | |
Trigger level accuracy (Typical) | Internal: ±0.3 div | |
Trigger displacement | According to record length and time base | |
Trigger hold-off range | 100 ns~10 s | |
50% level setting (Typical) | Input signal frequency ≧ 50Hz | |
Edge trigger | Slope, Rising, Falling | |
Video trigger | Modulation: Support standard NTSC, PAL and SECAM broadcast system | |
Line number range 1~525 (NTSC) and 1-625 (PAL/SECAM) | ||
Measure | ||
Cursor | ΔV, ΔT, ΔV and ΔT between cursors, auto cursor | |
Automatic measurement | Period, Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude, Overshoot, Preshoot, Rise Time, Fall Time,+PulseWidth, -PulseWidth, +Duty Cycle, -Duty Cycle, Delay A→ B , Delay A→ B , Cycle RMS, Cursor RMS, Screen Duty, Phase, +PulseCount, -PulseCount, RiseEdgeCnt, FallEdgeCnt, Area and Cycle Area. | |
Waveform Math | +,-, ×, ÷, FFT | |
Waveform storage | 16 waveforms | |
Lissajous figure | Full bandwidth, ±3 degrees phase difference | |
Waveform Generator (S model only) | ||
Waveform | ||
Standard Waveforms | Sine wave, square wave, ramp wave, pulse wave, arbitrary wave | |
Arbitrary Waveforms | Sinc, exponential rise, exponential decline,Gaussian more than 160 kinds | |
Waveform Characteristics | ||
Sine | Bandwidth: 0.1Hz~25MHz Bandwidth flatness (relative to 1 kHz Sine wave, 1Vpp, 50Ω) ≤10MHz: ±0.3dB ≤25MHz: ±0.5dB | |
Square | Bandwidth: 0.1Hz~5MHz, Rise/fall time:<30ns, Overshoot:<5% | |
Ramp | Bandwidth: 0.1Hz~1MHz Linearity: < 2% of peak output (typical 1 kHz, 1 Vpp, symmetry 50%) Symmetry: 0% to 100% | |
Pulse | Period: 200ns to 1Ms Pulse Width: 100ns | Rise/fall time: >12ns Overshoot: <5% |
Arbitrary | Bandwidth: 0.1Hz~5MHz, Waveform length: 8k | |
General Characteristics | ||
Bandwidth | 25MHz | |
Real-time Sample | 125M Sa/s | |
Amplitude(50Ω) | 0.005Vpp ~ 3Vpp | |
DC offset range (High Z) | ± (3V – amplitude Vpp/2) | |
Frequency resolution | 0.01% | |
Channel | 1 | |
Waveform Length | 8k | |
Vertical resolution | 14 bits | |
Output impedance | 50 Ω (typical) | |
Display | ||
Display type | 7-inch TFT LCD | |
Display resolution | 800 horizontal x RGB x 480 vertical pixels | |
Interface | ||
Standard interface | USB Host, USB Device | |
Probe compensation signal output | ||
Output voltage | About 5V with the peak to peak voltage | |
Frequency | Square wave of 1 KHz | |
Power supply | ||
Power supply voltage | 100V~240VAC RMS, 50Hz/60Hz, CAT II | |
Power | Max. 16W | |
Fuse | 2A, T class, 250V | |
Mechanical specifications | ||
Size | 301mm(W) x 152mm(H) x 70mm(D) | |
Weight | 1.1kg |